legacycentral bbs

GRR it was very cold this am single digits and the legacy would not start up.. I did get it started and before with the old cam sensor it would not start up.. but I did use my remote start so I think in the future I will just start it with the key when it gets this cold I will check it tommrow am..

starter contacts then most likely..

1990 - 1992 Subaru Legacy 2.2L Symptom: No start. Hard start and/or rough idle for a short time after first start cold. MIL stays on when idling rough. Codes 24 and 35. System: Emissions/PCM/Fuel Codes: 24, 35 Problem: The ignition relay has poor or intermittent contacts. Test & Fix: At the Yell...

Yes code 13 is the only one I got out of it.. this am it was 23 out and started right up.. I am so happy at the end of this week here it is planned to be in the single digits we will see if it can handle that.. do you need the part nunber for that relay? I saw a something on that with part numbers..

Just got back from the junk yard picked up 2 cam sensors.. tommrow morning is the test to see if she starts..

I think I may have the answer to my problem.... checked codes had code 13 in there (cam sensor) checked on identifix and found that the cam sensor will fail and cause no spark when cold I am going to get a new one and I will report back after I install a new one!

Just tryed to start my car this am and it is 18 out feels like 11 and no dice would not start turns over but no dice..?!? did ecu re-set producture yesterday and checked the wire-to coil fit all ok

Hello I would be willing to do this as a side job, I am a certified Master Mechanic in westminster/broomfield area if you need it done let me know Thank you in advance.

I have a simular problem with my 1992 legacy wagon auto trans awd, let me start by saying that.. I got this car cheap and had to pull the engine and go thorugh it, replaced all the gaskets, laped the valves in, so everything was cleaned/inspected it had a t-belt faliure and had compression issues.. ...