Need some help with fitting my version 3 TMIC
Moderators: Helpinators, Moderators
Need some help with fitting my version 3 TMIC
I swapped a Ver3 RA/STi engine and trans into my legacy. Need to make the Y-pipe longer. What should I use or build it out of? Looking for an easy durable solution. Any help is appreciated.
Re: Need some help with fitting my version 3 TMIC
Checked the sticky in this forum for ideas?
build forum also has lots of ideas from members cars.
build forum also has lots of ideas from members cars.
'11 WRX Limited
'94 SS | 3" TBE, 07 TMIC, TD05H-16G, Revtronix Stage 2, Walbro -- Sold
'94 TW | R.I.P.
Re: Need some help with fitting my version 3 TMIC
Ya, I wanna build something that will reach the turbo. didnt really get any ideas unless I overlooked a thread. But this is what im dealing with. the bottom pic is a test fit
Re: Need some help with fitting my version 3 TMIC
I have the same issue with my 02 wrx ic, I'm going to get a slicone e-bay y pipe and extend it by cutting it and adding a small section of pipe.
93 Turbo Wagon, 5mt swap, vlsd, sti slanty, vf10, alk, subframe lockout, gr2's, sti sways.
96 F-350 CCLB Powerstroke
89 Volvo 244, lsx swap
96 F-350 CCLB Powerstroke
89 Volvo 244, lsx swap