Sump removal on EJ20H

Heads, valves, pistons, rods, crankshaft, etc...

Moderators: Helpinators, Moderators

Post Reply
EJ20TMAN
In Neutral
Posts: 48
Joined: Mon Feb 17, 2003 4:20 am
Location: New Zealand
Contact:
Contact EJ20TMAN

Sump removal on EJ20H

Post by EJ20TMAN »

How do u pull the dipstick guild out of the sump??? its stoping me from removing the sump
1990 GT wagon JDM, TD05H, FMIC, Bosch coils 4in twin split dump 3 in rest of system, lowered, manual conversion, 17's, 17psi boost :) , tints, intake res gone and loving it!!!
Top
THAWA
Knowledgeable
Knowledgeable
Posts: 6829
Joined: Thu Aug 21, 2003 7:44 pm
Location: Sacramento, CA
Contact:
Contact THAWA

Post by THAWA »

Assuming it's like any other new gen engine it's bolted to the block near the top, remove that bolt then tug on it. It's in there kinda good. I think it has two o-rings that seal it in there.

Twist and tug I should say.
Rio Red 90 Legacy LS AWD 174k
Liquid Silver 92 SVX LS-L 88k
[url=http://folding.amdmbpond.com/FoldingForOurFuture.html]Do you fold?[/url]

I'm on First and First. How can the same street intersect with itself? I must be at the nexus of the universe.
Top
EJ20TMAN
In Neutral
Posts: 48
Joined: Mon Feb 17, 2003 4:20 am
Location: New Zealand
Contact:
Contact EJ20TMAN

Post by EJ20TMAN »

Ahhh, ok i was thinking about pulling it but it felt real in there, thanks man
1990 GT wagon JDM, TD05H, FMIC, Bosch coils 4in twin split dump 3 in rest of system, lowered, manual conversion, 17's, 17psi boost :) , tints, intake res gone and loving it!!!
Top
Post Reply

Return to “Engine”