legacycentral bbs

sometimes the light is on when i first start it and other times it is off until it runs for 5 min.

so a bad ecu can do that. is it a common thing. how hard are they to swap.

i don't remember how many flashes it was but i am sure it was the o2 sensor code. the light was not on when i got the car a year ago. one day it just started to come on. since i replaced the sensor it will sometimes be out when i start the car but after about 5 minutes it comes back on and stays on.

yes i did reset it, the only code was the o2 code

the car runs good and there are no exhaust leaks. today when i started it the light was out until the car warmed up then it came back on.

where does the wiring go to. is there a plug at the other end

on my 90 legacy i got a check engine light that said i had a bad o2 sensor. i got one from the local parts store and the light would be out when first started in the morning but after 5-10 min. it would come back on. i was told i probably got a bad sensor. i went to the subaru dealer and got one and...

thanks, i will have to check into that

the fuel gauge in my 90 legacy always reads empty. where is a good place to start looking. is there a way to see it the low fuel light works.

one more question (i think). when lowering the rear of the trans down to get the tail housing off, do i have to unhook anything like the shifter.

i went to the subaru dealer, the told me all the parts,clutches solonoid seals etc. would cost $315. then they said something had to be pressed out and they had to use a micrometer to make sure everything was strait. they said it would take 3-4 hours and cost $150-200 for labor. thats if i pull the ...

i just measured my tires. the front is about a 1/2-3/4 inch taller than the rear. they are same size but different brands. is that enough to fry the clutches?

e-brake is good and i will check the fluid

i will recheck them but i think they all work

when i turn on the lights it comes on until i tap the brake pedal then it goes out until the next time the lights are turned on. their are no lights out?

the wires are CONNECTED to the cd player. well i'm sure not gonna cut the wires off just because i have no amp. go to the store and look at a cd player. look at the wires. their are rca and amp turn on wires that come out of the back with the power, ground, speaker wires. it is possible to use a cd ...

i never said i had an amp. the rca and blue wire are behind the cd player and i moved them around.

it IS possable to have a cd player with these wires and not have an amp!

sorry i've been busy and didn't have time to use the computer. could the rca cables or the blue amp turn on wire touching something do it. i moved them around and it stopped. has not done it since.

it has a cd player in it but thats been in their for a while. i got a set of speakers and i put the 2 rear ones in and got the noise. havent done the front yet. i used the wiring that was already there. i drove around with them in and they sounded great. then i started getting that noise. it's not t...

i put new speakers in today and they worked great. now their is this humming noise that gets louder as the engine revs up. it's only in the rear speakers and after it did it, it quit for a while then came back ?

why are the 90 keys different. the one in our 96 will fit in the 90 but just won't turn it.

how hard is it to replace one on the front.

http://www.libertysubaru.com/en_US/
i just found this and maybe they have the clutches

is there anyone that has got new clutches and knows how many are needed

is this what i would need. and how many would i need.

http://www.bulkpart.com/Merchant2/merch ... ode=23118A

where can i buy them