Search found 2206 matches

by wtdash
Fri Jun 19, 2020 9:14 pm
Forum: Car Lot - Craigslist/eBay
Topic: 1993 LSi 38K - WA
Replies: 0
Views: 137

1993 LSi 38K - WA

EBAy: https://www.ebay.com/itm/1993-Subaru-Le ... 000%7C2500

Front driver's fender either faded or replaced and burn marks on driver's seat? Otherwise, clean car.
by wtdash
Tue Jun 16, 2020 12:22 am
Forum: Turbo
Topic: Looking for the right turbo
Replies: 3
Views: 208

Re: Looking for the right turbo

Late to the thread, but wanted to confirm everything MT stated. I've run them all, too. ...well actually I had a VF24 vs. the VF23, so I lie, but the TD05 is a 'high-RPM' beast. I'd rebuild that VF23 before buying anything else. NASIOC may still be the best place to buy turbos, but I've not been on ...
by wtdash
Thu Apr 30, 2020 1:52 pm
Forum: Engine
Topic: Install Passenger turbo head only??
Replies: 5
Views: 560

Re: Install Passenger turbo head only??

HI, Yes, stock. There are many tales of turbos on the stock EJ22e spread around this site and online. I never got this project off the ground, but as noted did an earlier one here: https://www.ultimatesubaru.org/forum/topic/157674-1996-legacy-l-turbocharged/ That car was bought by a self-proclaimed ...
by wtdash
Thu Mar 26, 2020 3:12 am
Forum: Ashtray
Topic: 1993 Ford Spectron XL-T
Replies: 13
Views: 1231

Re: 1993 Ford Spectron XL-T

ImageWhat? I thought they were from a Leone/Loyale? But I obviously didn't look close enough.
by wtdash
Sun Mar 22, 2020 12:48 am
Forum: Ashtray
Topic: 1993 Ford Spectron XL-T
Replies: 13
Views: 1231

Re: 1993 Ford Spectron XL-T

Wheel covers= Nissan Pulsar? I haven't googled it yet.
Wait....a real Ford? Like a Mercury LN7? But you're pretty JDM, so I'd stick w/something from Japan. :-)

Edit: I should've known....now I do.
by wtdash
Wed Mar 11, 2020 12:14 am
Forum: Car Lot - Craigslist/eBay
Topic: JDM Imports
Replies: 0
Views: 482

JDM Imports

No affiliation, but they have some very fine 1st Gen Legacy models. Not cheap, but also not crap. Duncan Imports in TN https://i.imgur.com/Cuduy20.jpg https://i.imgur.com/peUte20.jpg https://i.imgur.com/7HWVWu3.jpg And this Nissan Pulsar GTI-R is super hot-hatch that I'd put in my garage: https://i....
by wtdash
Fri Feb 21, 2020 6:41 pm
Forum: Intake
Topic: '98 Legacy Outback Cold Air Intake
Replies: 1
Views: 329

Re: '98 Legacy Outback Cold Air Intake

HI - and welcome. This forum caters to the older '89-'94 models, but your '98 is similar. LegacyGT.com and UltimateSubaru.org site may also have good info. Most- if not all- Subarus (as do most brands) had CAI from the factory. If you look at where your air comes in, it's from inside the fender line...
by wtdash
Fri Jan 10, 2020 7:37 pm
Forum: Engine
Topic: Car stalling while driving
Replies: 28
Views: 972

Re: Car stalling while driving

Rumor is not to use carb cleaner or anything w/too strong/forceful a spray - to avoid damaging the element. So sensor kleen FTW.
by wtdash
Fri Jan 10, 2020 6:28 pm
Forum: Ashtray
Topic: Dankberries STi s209
Replies: 14
Views: 1014

Re: Dankberries STi s209

Congrats on nabbing one. Not asking for $$, but did the dealer add a healthy profit to the sticker? Kinda like when anything rare 1st comes out. Ford dealers are notorious from what I've read. Regardless, unless money is a consideration (and based on this post I'd guess it's secondary) I'd wait 'til...
by wtdash
Fri Jan 10, 2020 5:54 pm
Forum: Engine
Topic: Car stalling while driving
Replies: 28
Views: 972

Re: Car stalling while driving

I'd still get another MAF. Used is OK, although they do fail, it's not super common. Unfortunately the turbos used the rare metal MAF. They were also used on the '90-'91 (?) 5-speed Legacy, if you're lucky to a have a pullnsave/used auto parts nearby. New may be $pendy and/or hard to find. The plast...
by wtdash
Thu Jan 02, 2020 9:38 pm
Forum: Engine
Topic: Car stalling while driving
Replies: 28
Views: 972

Re: Car stalling while driving

"First off I can't hear the fuel pump running when I switch on the key, and when I pop the fuel cap there's no pressure..." Time to install a DW fp (or similar). If you bought a used Subaru, you 'must' be able to wrench, correct? :D But check the relay and wiring 1st (you'll want to google/search he...
by wtdash
Wed Jan 01, 2020 12:11 am
Forum: Parts Shed
Topic: Ej22t shortblocks
Replies: 5
Views: 509

Re: Ej22t shortblocks

There are lots of threads in the Parts Shed (Ads) for Buyers wanting them...in the past. I'd reach out to see if there's still interest. You can also list them on Ebait...including the UK version..and likely get some interest. I sold two (sets of block halves) and both were well worth the trouble $$...
by wtdash
Tue Dec 31, 2019 11:57 pm
Forum: Engine
Topic: Car stalling while driving
Replies: 28
Views: 972

Re: Car stalling while driving

I'd read thru the 5-speed swap here: https://www.surrealmirage.com/subaru/swap/swap.html
To see what is required (i've since forgotten). May be some clues.
by wtdash
Tue Dec 31, 2019 11:54 pm
Forum: Engine
Topic: Can't reset ECU?
Replies: 13
Views: 2395

Re: Can't reset ECU?

HI, I'd strongly suggest searching on here/online for microphone (or just mic) wire for the KS. Those wires are all suspect under the throttle body/intake manifold. FWIW, my 1st EJ22T had the same issue, seemed to run OK, but was in limp mode. Fixed the KS and had full boost (and ignition advance) -...
by wtdash
Wed Nov 06, 2019 5:28 pm
Forum: Car Lot
Topic: 1994 Subaru Legacy touring wagon
Replies: 2
Views: 1201

Re: 1994 Subaru Legacy touring wagon

Email sent on CL.
Thanks
by wtdash
Mon Oct 28, 2019 2:01 am
Forum: Parts Shed
Topic: WTB: JDM 440cc Grey Side-feeds
Replies: 2
Views: 486

Re: WTB: JDM 440cc Grey Side-feeds

PM'd.
by wtdash
Sat Sep 28, 2019 9:11 pm
Forum: Electrical
Topic: The infamous limp mode!!!(5psi)
Replies: 23
Views: 1237

Re: The infamous limp mode!!!(5psi)

Where is the subaru select monitor connector on the factory harness for a Legacy SS? i might try and see if a subaru shop can plug into it. Not sure on your swap, but it's the YELLOW connector near the driver's right knee on the stock SS. If you build a cable (search on here) you can use some of th...
by wtdash
Sat Aug 31, 2019 11:51 pm
Forum: Engine
Topic: EJ22T Swap into NA Legacy - The List....
Replies: 22
Views: 6304

Re: EJ22T Swap into NA Legacy - The List....

I missed the oil squirter question, and I don't know. Josh Colombo (legacy777) or Mike Tracy may know about that.
by wtdash
Sat Aug 31, 2019 8:42 pm
Forum: Engine
Topic: EJ22T Swap into NA Legacy - The List....
Replies: 22
Views: 6304

Re: EJ22T Swap into NA Legacy - The List....

NO offense, but your MBC can only INCREASE PSI not reduce. You're limited by the WG PSI. Maybe an EBCS can lower it? But I don't think so. Per http://www.hallmanboostcontroller.com/faq.html : Can I lower my boost with a boost controller? A: No. With any boost controller you can only raise boost abov...
by wtdash
Sat Aug 31, 2019 7:36 pm
Forum: Engine
Topic: EJ22T Swap into NA Legacy - The List....
Replies: 22
Views: 6304

Re: EJ22T Swap into NA Legacy - The List....

The reds are 270cc or so. I think all the 2.2 and 2.5 reds from '92-'98 were the same. And just to clarify the DOHC side-feed fuel rails are interchangeable between engines, including NA vs. turbo. BUT the injectors are not. Actually ...the best option...IMHO...is to run those @ WG boost until you g...
by wtdash
Sat Aug 31, 2019 3:24 am
Forum: Engine
Topic: EJ22T Swap into NA Legacy - The List....
Replies: 22
Views: 6304

Re: EJ22T Swap into NA Legacy - The List....

Argh..yeah, I missed that 'little' tidbit about fuel rails. You'll need to source the EJ20G DOHC rails to use the EJ22T injectors. THAT could be tough......you might find on here about modding the SOHC rails to fit, but can't recall for sure if that's an option. Off the top, I cant recall any other ...
by wtdash
Fri Aug 30, 2019 5:17 pm
Forum: Engine
Topic: EJ22T Swap into NA Legacy - The List....
Replies: 22
Views: 6304

Re: EJ22T Swap into NA Legacy - The List....

Also...since this is your DD, I'd get it running 'stock' w/the stock pinks, ECU, MAF, etc. It'll run great 'as is'. With TMIC and VF28, you can run just under the fuel-cut of the ECU - about 12 PSI w/an MBC. I'd guessitmate close to 180HP/Torque at the wheels....a big jump over the stock turbo's pow...
by wtdash
Fri Aug 30, 2019 5:06 pm
Forum: Engine
Topic: EJ22T Swap into NA Legacy - The List....
Replies: 22
Views: 6304

Re: EJ22T Swap into NA Legacy - The List....

Either I'm out of the loop or you've not had a chance to read 'all about it'. The stock EJ22T ECU is not tunable by Rob. He can only supply a tunable CHIP that goes into an EJ20G ECU's 'add-on' location, which must be soldered into the ECU unless you have a '7D' ECU. Rob can sell you a 'chipped' ECU...
by wtdash
Fri Aug 30, 2019 4:20 pm
Forum: Engine
Topic: EJ22T Swap into NA Legacy - The List....
Replies: 22
Views: 6304

Re: EJ22T Swap into NA Legacy - The List....

^+100
EJ20G and Robtune info: viewtopic.php?t=47252

440cc Gray tops are getting hard to find. Some sellers on https://www.ebay.co.uk/ will ship to the USA.