quiet clicking on slow speed coast, and whining only on throttle, higher pitch with tire speed, kinda like revese whine, only happened over 15 mph on up.
Tried replacing rear exstention case, gears, clutches, no change, so replaced whole trans, problem fixed. think a gear out of line maybe planatary ...
Search found 5 matches
- Mon Aug 04, 2008 11:14 pm
- Forum: Misc
- Topic: past problems i've had with 90 legacy, whining, dying
- Replies: 0
- Views: 516
- Mon Aug 04, 2008 10:39 pm
- Forum: Drivetrain
- Topic: Duty C solonoid replacement.
- Replies: 16
- Views: 3028
- Sun Aug 03, 2008 8:20 pm
- Forum: Engine
- Topic: Noisy Lifters Just An Annoyance?
- Replies: 8
- Views: 2056
cleaned mine in the winter and and had no tick since, mine was pretty loud could hear them driving down the highway.
replaced two and cleaned the rest. i do think cleaning the supply holes on the rocker arms helped. i used my old guitar wires to clean the channels out. knew they would come in handy!
replaced two and cleaned the rest. i do think cleaning the supply holes on the rocker arms helped. i used my old guitar wires to clean the channels out. knew they would come in handy!
- Sun Aug 03, 2008 7:50 pm
- Forum: Drivetrain
- Topic: Duty C solonoid replacement.
- Replies: 16
- Views: 3028
just did mine last night and another today, the connector is wedged in the ex housing, simply pull on the connector and you'll get about 3 inches of slack.
also i put the clutch pack on and spin with hand till seated and there was room for me to slide casing over the shaft .
want any pics let me know
also i put the clutch pack on and spin with hand till seated and there was room for me to slide casing over the shaft .
want any pics let me know
- Sun Aug 03, 2008 7:37 pm
- Forum: Drivetrain
- Topic: 4eat torque converter question
- Replies: 4
- Views: 1370
had the same problem ended up that the input shaft "not the hollow oil pump shaft or tc" was not seating, and after 2 hours trying, i removed the input shaft and when putting back in, i kept pushing and turning and it went in the rest of the way. then i put the tc clipped to the oil pump shaft on ...