legacycentral bbs

must i use the exact model axle for the car ie ; 91 ss 5mt axle or is it possible to grab one from another vehicle for the time being , ie 98 wagon 2.5gt 4eat or 93 LS 2.2 4eat etc - either is availalbe to me

i m glad you re all so confident the thing is busted

it s the third or fourth time i ve straightened the boot out to normal shape to have it do this every time

Would a shrill-whirrllling sound be caused by a bad axel , and vibrate the shifter also ? - i ve reset the boot to its normal shape like an accordian and when i park and check the boot it looks like this > :? i know i pinched the boot causing the grease leak when removing the motor , the downpipe sn...

Now that the car is moving under its own power , i discovered this mess after the motor swap ; it now has a new axle and AWD again , http://i209.photobucket.com/albums/bb303/N1446-W0963/DSCN02722.jpg - since the car was stationary without a motor and the brakes seized from it not moving, i had to ha...

i made sure the bearing was "locked" in place with the clutch already , then i mated the trans-engine , as i brought the two together i made sure the fork was in the correct posistion though as i further mated the engine to trans its hard to say everything when together properly :? i didn ...

it is a turbo with a 2.5 DOHC swap using 22T clutch and flywheel i read this is the way the clutch is meant to be set before mating the engine to trans http://i209.photobucket.com/albums/bb303/N1446-W0963/clutch.jpg i did not do it this way , i installed the bearing loose on the spindle , though con...

tested a paint color on the body and found the color is too white for the car - pearl white duplicolor is NOT the same as 91 SS pearl white :lol: - repaired a nasty fuel line , verified the radiator fans turn on properly - picked up a fog light switch from the boneyard and front sidemarker lights -

Am i safe using the one i have once it is installed correctly ? >what are the chances the TOB is useless because it was not clicked* / seated properly - in other words it s been spinning freely on the drive line since it s been mated or somthing it did not CLICK* in place after a DIY attempt i know ...

yeah - not to mention its a weight reduction so it has to be faster now too

i found the picture where you moved the ground up high on the seat back - As it turns out the relay is not the issue , the R22 connection is the RFO i picked one from a RHD postal wagon :o and spliced it in place of the original - when the key turns to on it gurgles for two seconds when the key is i...

it s a nasty effort , i peeled the chrome strip and it left a thick white double-sided adhesive layer behind ; i used brake fluid and a flat head screwdriver to soften the adhesive and scrape\maul\chissel it away

took like an hr

yeah no kidding i aim to eventually be headding west myself ! i hear the weather is Much more reliable ! -- as for the latest updates , they re only cosmetic and it looks as if it may be ready for the fall -- The 2.5L install is covered in the Journal Post along with anything else releated to the EJ...

the homestead squad since we're sharing n all :D thatz his & hers and young sis in the back 2000outback limited , 2005 2.5rs and 97 2.5gt http://i209.photobucket.com/albums/bb303/N1446-W0963/DSCN01744.jpg [/img] http://i209.photobucket.com/albums/bb303/N1446-W0963/DSCN01755.jpg http://i209.photo...

Ok Great :!: - today i picked up another relay from the 93 LS i sent to the boneyard a while back - I also found your post Josh on switching the fuel sender for one thats larger - i take it the location for the pump ground you chose works fine - the pics are right on , i m getting after it later tod...

Sick
Thankyou asc_up
it will be nice to find the gremlin

is it up under the steering column area ? the Haynes FSM i have has next to nothing in it for Fuel system troubleshooting Pic ?

ok the pump runs off direct 12v when everything is connected in the car it will not turn on in the ON position even though there is voltage present - approximately 10v the car is meant to presurize the line when its in "ON" correct ? - is there a relay or fuse that is connected to the igni...

i m convinced it doesn t get charge at all i sit in the car with all windows and doors shut and i fold the rear seat down and remove the pump cover then switch the key to "ON" .. but silence .. , the car will crank forever when i turn past "ON" w\c no fuel no click or humm or any...

seriously though is the pump toast or is it salvage-able ?
with power to the pump no noise - no click - not anything- no start

here s an idea
u stand on the front bumper and dump fuel in the motor while i play with the gas

i got everything together after the car is sitting for a while , I ve read the legacy fuel pumps "give-up" after sitting for extending periods for what ever reason , i pulled the rear seat and tested the voltage on the conector from the loom under the seat and on the pump and there are lik...

1987 GPZ305 - very clean & belt driven - sold age 16 1988 ZX600R favorite light-weight bike sold 17 1992 ZXR750 favorite superbike - traded 23 1990 audi 90 Quattro 20v - Wrecked 21 - favorite SS - subject to change* 1990 Toyota celica gt 5mt to work and back' 24 1983 pontiac firebird se 5.0 T-ro...

ok here i have a 22t harness & ecu with a 25d engine together - i ve kept the sst engine harness near OEM as possible , concidering a few clip alterations and wire extentions 1st up ? are the crank angle and cam angle sensors between the years concidered the same-as in signal to the ECU- or diff...

it s not in the forcast to sell the block , the 2.57 crank idea is attractive , though originally the idea is to put the 25D crank and rods in there until i work out a reasonable set up for turbo , ecu etc .. i m collecting parts for the spring again and more likely i ll have the block checked over ...

EJ25D installed in a MY'91 turbo Chassi + ECU I almost forgot ,, Installation is the reverse of removal - SSeriously though it not so bad http://i209.photobucket.com/albums/bb303/N1446-W0963/DSCN01044.jpg 22T5mt items swapped onto phase 1 EJ25D engine - pwer steering pump alternator MAF flywheel co...