legacycentral bbs

Wanting to buy a spare ecu. Maf, tps, and a few more things.

If you got any of the above hanging out in the garage taking up space, let me know.

Thanks,
Eli

I believe all the hoses going into the intake tube are connected and good. I have pulled the intake a couple of times, to change the PCV valve connector and also to change the temp sensor. They all held what pressure I could put on them from plugging them and blowing into them. They all seem pliable...

Did the maf checking, things seemed to check out as far as ranges. Took it for a quick road test with both connectors on, ran really bad, got almost back home and started throwing code 32. I don't get it, I just replaced the o2 last week with a new Bosch one. I am really at a loss of why it is actin...

This is what the P.O. Told me he purchased. http://www.amazon.com/gp/product/B000C45JHI/ref=oh_aui_detailpage_o06_s01?ie=UTF8&psc=1 Good, bad or ugly, I don't know. I appricate the scans, gives me something to tinker with. I am waiting on the pcv t, I broke it when tinkering around. The junk yar...

I have gone through and corrected all the issues with the active codes. I have not cleared the stored codes, since I am having issues with being able to road test it, or letting it run without touching the throttle. I have also run active diagnostic code, does not bring anything up. I have let it tu...

I did the tps test out with the iac valve soak. It was just a touch off at pin 1&2 test out at .035. The rest was close according to the spec, as fat as throttling up and down with an ohm gage, no big jumps or anything.

I soaked the iacv with sea foam last night, worked better for a while but back to jumping from 500 to 750 rpm. When I put it in gear it has enough load to kill it when it is idling like that. I will most likely pull it and hand clean it next, just trying to find a gasket in case I ruin mine during d...

Don't know how to start this besides I am new here, have done a ton of reading past issues, and just can't seem to find that last little bit to get me where I need to be. Backstory. Bought a 1993 legacy wagon 161xxx, at, awd, na, a about a moth ago, have been plugging away at the codes to get it run...