legacycentral bbs
https://bbs.legacycentral.org/

Electrical Compilation Thread Sticky
https://bbs.legacycentral.org/viewtopic.php?f=19&t=41764
Page 1 of 1

Author:  Legacy777 [ Sun Nov 01, 2009 10:46 pm ]
Post subject:  Electrical Compilation Thread Sticky

How to read Check Engine Light Codes
Legacy Turbo ECU Pinout Diagram Needed
First Gen Turbo Legacy ECU I/O Spreadsheet
An ECU scan tool for turbo and NA owners
Alarm/Remote Starter wiring info UPDATE #2
My new project -- a standalone scan tool (lots of pictures)
Factory plug fix
THE EJ20G ECU Thread
How to read the codes from auto seatbelt computer
EJ20G "RobTune" Info
Rob's 4to2 Igntion Converter
3 wire to 2 wire alternator plug conversion info
Radio Wire Diagram
Behind Dash Relay Location Guide With Pictures!
Reading Electrical Connector Diagrams & Pin Numbering
Variable Intermittent Wiper Upgrade - DIY with pictures
How-To: Convert To GD WRX Coil On Plug w/EJ20G ECU
Apexi AVC-R install
Select Monitor or Scan Tool Check Sheet
Electronic Legacy gauge cluster into a US Legacy
Shielded Wire Replacement
Alternative ECU Patch/Test Harness Options
Reading Electrical Connector Diagrams & Pin Numbering

Author:  PhyrraM [ Mon Nov 02, 2009 1:33 am ]
Post subject: 

Great idea!! I refer to the engine forum on all the time.

Taking suggestions?

I seem to refer tons of folks from other forums to these two threads of mine. Maybe the sticky would be a good place to flag them?

"Need electronics help", the thread where we outlined if it was poosible to run a 4 channel ECU with the factory harness.
viewtopic.php?t=35093

And the eventual "how-to" thread. However, upon re-reading it, it could use some clarification. I'll try working on it if there is enough interest.
viewtopic.php?t=37071

Author:  Legacy777 [ Mon Nov 02, 2009 4:31 am ]
Post subject: 

Let me know when you're happy with the threads, I will add to the sticky post.

Author:  GarageBuilt [ Tue Sep 29, 2015 6:11 pm ]
Post subject:  Re: Electrical Compilation Thread Sticky

Perhaps SAFC settings and info would be good to add? Considering it's the most commonly used and easiest to operate air/fuel controller.

Author:  mike-tracy [ Thu Sep 29, 2016 11:05 pm ]
Post subject:  Re: Electrical Compilation Thread Sticky

Hi GarageBuilt, I am not aware of any current members (besides yourself) who are using it. If you want to create a thread on the ins and outs, installation, tuning and results, I can ask the administrator if we can add it to the sticky.

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/