Page 3 of 3
Re: ej22 na turbo help pls
Posted: Sun Dec 14, 2014 5:16 am
by Legacy777
Ok, good to know.
Re: ej22 na turbo help pls
Posted: Mon Dec 29, 2014 5:57 pm
by bcmaxx
Looking for a bit more fuel. At 16psi its a bit lean at 12,3 ish when im hard on the gas. Rrfpr is maxxed. Can i do anything to the stock injectors or swap in my ej22t injectors and rails ? Im on the smallest water injection nozzle. Upping one size help?
Re: ej22 na turbo help pls
Posted: Tue Dec 30, 2014 11:58 pm
by Legacy777
You wouldn't really be able to swap injectors since the ECU is matched with the injectors and swapping in a turbo Legacy ECU isn't going to work either.
Do you have a higher flow fuel pump? You could try a different RRFPR with an increased rising rate.
Re: ej22 na turbo help pls
Posted: Wed Dec 31, 2014 2:50 am
by bcmaxx
Ive decided to run lower boost until i get the turbo block finished and in. It will likely have different fuel demands with a lower cr. Currently running a holly variable rrfpr and meth injection
Re: ej22 na turbo help pls
Posted: Sun Jan 04, 2015 12:12 am
by bcmaxx
Fixed! It was suggested I clean my maf, cleaned, and now I have all the fuel i need.
Re: ej22 na turbo help pls
Posted: Wed Jan 07, 2015 6:55 am
by bcmaxx
Another odd question. I need to replace my turbo oil feed line. My bastards tee fitting off the oil press sensor location is leaking a bit. What is recommended size? Im using 1/4 inch tubing at the moment.
Re: ej22 na turbo help pls
Posted: Wed Jan 07, 2015 1:49 pm
by cj91legss
The first post of this thread
http://sl-i.net/FORUM/viewtopic.php?f=39&t=22065 shows you a good option for an oil feed line for the factory non turbo setup.
Might be something to try?
Re: ej22 na turbo help pls
Posted: Wed Jan 07, 2015 5:11 pm
by bcmaxx
Thanks! I found another on there too
http://www.ebay.ca/itm/MK1-Turbo-Oil-Fe ... RTM1963930
but not sure if it will work?