will it fit?

Headers, cats, uppipes, downpipes, midpipes and mufflers.

Moderators: Helpinators, Moderators

Post Reply
turbo970
Third Gear
Posts: 859
Joined: Sun Jul 15, 2012 11:50 pm
Location: sw colorado

will it fit?

Post by turbo970 »

i saw this vibrant resonator and wondered if it will fit under my tw?
http://www.ebay.com/itm/New-1142-Vibran ... 02&vxp=mtr
Legacy777
Site Admin
Site Admin
Posts: 27884
Joined: Tue Oct 15, 2002 11:37 am
Location: Houston, Tx
Contact:

Re: will it fit?

Post by Legacy777 »

That's a pretty decent size resonator. Mine is not much wider in diamater than the 3" piping. You can see a picture of it here

http://main.experiencetherave.com/subar ... P_5191.JPG

More pics of the exhaust here
http://main.experiencetherave.com/subar ... s/ej22t/25
Josh

surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT

If you need to get a hold of me please email me rather then pm
turbo970
Third Gear
Posts: 859
Joined: Sun Jul 15, 2012 11:50 pm
Location: sw colorado

Re: will it fit?

Post by turbo970 »

so i should go for the 3" in /out with the 4" body?
Legacy777
Site Admin
Site Admin
Posts: 27884
Joined: Tue Oct 15, 2002 11:37 am
Location: Houston, Tx
Contact:

Re: will it fit?

Post by Legacy777 »

That should fit fine.
Josh

surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT

If you need to get a hold of me please email me rather then pm
turbo970
Third Gear
Posts: 859
Joined: Sun Jul 15, 2012 11:50 pm
Location: sw colorado

Re: will it fit?

Post by turbo970 »

i hope a 5" body clears cuz that all i could find. 3" in / out and 16" long should be here next week along with my obx twin tip muffler
kimokalihi
Fifth Gear
Posts: 8360
Joined: Mon Nov 06, 2006 3:41 am
Location: Tenino, WA

Re: will it fit?

Post by kimokalihi »

It'll fit but depending on how low you are you might scrape it on speed bumps and stuff. Mine is much smaller than that. 3" in and 3" out. I think I got it on summit racing but I can't remember for sure but it just looks like the pipe gets a little bigger where the resonator is and I've still scraped it pretty good on the really wide speed bumps at costco and a couple other places as well.
98 Metro Hatch Daily Driver :)
91 SS EJ20G Engine/Tranny/Diff Swap Build Thread Here
"Your testes are close to your bottom but you still play with them all the time." Jeremy Clarkson
turbo970
Third Gear
Posts: 859
Joined: Sun Jul 15, 2012 11:50 pm
Location: sw colorado

Re: will it fit?

Post by turbo970 »

i'm at factory height but the pipe hangs low so they are going to redo the exhaust
turbo970
Third Gear
Posts: 859
Joined: Sun Jul 15, 2012 11:50 pm
Location: sw colorado

Re: will it fit?

Post by turbo970 »

http://www.ebay.com/itm/OBX-Stainless-S ... 2e&vxp=mtr

thats what i ordered i just hope it dont rub the drive shaft
Post Reply