I haven't found much local support by searching, and Calgary is a very expensive city in general (looking at $40 per injector without new screens or o-rings), so I started looking at places I could ship my injectors for service.
Witchhunter has stopped service outside of the USA, so I was looking for other places.
Accurate Injector Service, based out of Arizona, looks like a nice option. For $25 per injector they test before and after, clean, replace seals etc., clean the rails, pressure test in the rail and ship back installed.
http://accurateis.com/store/before_after_01a.php
I asked them if they will ship to Canada.
Injector cleaning, including rails and o-rings
Moderators: Helpinators, Moderators
-
- Third Gear
- Posts: 908
- Joined: Wed Dec 06, 2006 11:24 am
- Location: Calgary, AB
Injector cleaning, including rails and o-rings
Andrew
16 Outback - wife's daily
95 Gravel Express - Sold
92 Green SVX - RIP
02 WRB WRX - Sold
93 White SS "Angel": 4EAT to 5MT 550 Robtune !SOLD!
̶9̶2̶ ̶W̶i̶n̶e̶s̶t̶o̶n̶e̶ ̶S̶S̶ ̶5̶M̶T̶ R.I.P.
16 Outback - wife's daily
95 Gravel Express - Sold
92 Green SVX - RIP
02 WRB WRX - Sold
93 White SS "Angel": 4EAT to 5MT 550 Robtune !SOLD!
̶9̶2̶ ̶W̶i̶n̶e̶s̶t̶o̶n̶e̶ ̶S̶S̶ ̶5̶M̶T̶ R.I.P.
Re: Injector cleaning, including rails and o-rings
Josh
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
Re: Injector cleaning, including rails and o-rings
There is a place in Kelowna that the guys have had good luck with, maybe Interior Injection or Okanagan Injection. They cleaned/balanced injectors for bmxkelowna and nosyt, maybe PM them to see. I think it may have been around $100/set?
99 Outback
92 Legacy Turbo 5 speed
92 Legacy Turbo 5 speed
-
- Third Gear
- Posts: 908
- Joined: Wed Dec 06, 2006 11:24 am
- Location: Calgary, AB
Re: Injector cleaning, including rails and o-rings
So after I pulled the rails with expectations of shipping them for service, I noticed that my leaky injector in question did not have its cap tightened down.
I couldn't see that from above when they were in. I suppose if I'd thought to check I might have felt it or seen from the right angle.
The screws turned easily and the cap went flush. So I assume that would eliminate the leak I had observed.
So now it is a choice of long term versus short.
Could send them both to be cleaned and rebuilt since they are already out.
Or, since the only seal exposed was the spacer, I could replace those ans put them back in as is. I would then trust all the seals and be able to determine if tightening the cap fixed the problem.
Sent from my Nexus One using Tapatalk 2
I couldn't see that from above when they were in. I suppose if I'd thought to check I might have felt it or seen from the right angle.
The screws turned easily and the cap went flush. So I assume that would eliminate the leak I had observed.
So now it is a choice of long term versus short.
Could send them both to be cleaned and rebuilt since they are already out.
Or, since the only seal exposed was the spacer, I could replace those ans put them back in as is. I would then trust all the seals and be able to determine if tightening the cap fixed the problem.
Sent from my Nexus One using Tapatalk 2
Andrew
16 Outback - wife's daily
95 Gravel Express - Sold
92 Green SVX - RIP
02 WRB WRX - Sold
93 White SS "Angel": 4EAT to 5MT 550 Robtune !SOLD!
̶9̶2̶ ̶W̶i̶n̶e̶s̶t̶o̶n̶e̶ ̶S̶S̶ ̶5̶M̶T̶ R.I.P.
16 Outback - wife's daily
95 Gravel Express - Sold
92 Green SVX - RIP
02 WRB WRX - Sold
93 White SS "Angel": 4EAT to 5MT 550 Robtune !SOLD!
̶9̶2̶ ̶W̶i̶n̶e̶s̶t̶o̶n̶e̶ ̶S̶S̶ ̶5̶M̶T̶ R.I.P.
-
- Third Gear
- Posts: 908
- Joined: Wed Dec 06, 2006 11:24 am
- Location: Calgary, AB
Re: Injector cleaning, including rails and o-rings
I mailed them to AIS today.
I'm curious to see the before and after test data, and it will be one component I don't need to worry about going forward.
Sent from my Nexus One using Tapatalk 2
I'm curious to see the before and after test data, and it will be one component I don't need to worry about going forward.
Sent from my Nexus One using Tapatalk 2
Andrew
16 Outback - wife's daily
95 Gravel Express - Sold
92 Green SVX - RIP
02 WRB WRX - Sold
93 White SS "Angel": 4EAT to 5MT 550 Robtune !SOLD!
̶9̶2̶ ̶W̶i̶n̶e̶s̶t̶o̶n̶e̶ ̶S̶S̶ ̶5̶M̶T̶ R.I.P.
16 Outback - wife's daily
95 Gravel Express - Sold
92 Green SVX - RIP
02 WRB WRX - Sold
93 White SS "Angel": 4EAT to 5MT 550 Robtune !SOLD!
̶9̶2̶ ̶W̶i̶n̶e̶s̶t̶o̶n̶e̶ ̶S̶S̶ ̶5̶M̶T̶ R.I.P.
Re: Injector cleaning, including rails and o-rings
Good plan
Josh
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm