need help!!! right control arm

[t2402j]

My friend had a 94 legacy, it had a recent acciendent, the fenders gone, endlink got cut in half, and control arms bent.. just recenlty bought a control arm and endlink from a 95 outback.. but now I cant put in on there..
Question??
Did I buy the wrong part??
Is the frame bent too?
Heres the pic of the broken arm

[t2402j]

Btw he said if I fix it its mine.

[PhyrraM]

A '95 Outback should use the same control arm, but the rear bushing is different to accommodate the factory 'lift'. It should still bolt in though.

I would look for signs that the crossmember or the rear bushing mounts are out of shape. Maybe the crossmember is out of place?

[t2402j]

A '95 Outback should use the same control arm, but the rear bushing is different to accommodate the factory 'lift'. It should still bolt in though.

I would look for signs that the crossmember or the rear bushing mounts are out of shape. Maybe the crossmember is out of place?

heres more pics

[Legacy777]

When you try and bolt up the new control arm, where does it seem like it has issues fitting?

[t2402j]

When you try and bolt up the new control arm, where does it seem like it has issues fitting?

The right side hanger.. the one in the last pic.. maybe its twisted?.. how can I fix it?

[Legacy777]

You mean the front mount on the engine crossmember? How does the other side of the crossmember look, does it look bent? If you mount the front part of the control arm first, how does the rear line up?

[PhyrraM]

I don't recall a big wrinkle like that in the crossmember. I agree....compare it to the other side.

[t2402j]

still have to check the car is at a parking lot at my work.. if the crossmember is bent.. do i have to replace it?.. can i take that off w/o a lift?

[PhyrraM]

Yes, you can take it off without a lift. Place jackstands in the usual locations, and then place the jack under the motor to hold it up while swapping the crossmembers.

[t2402j]

finnaly figured it out






thx for the help guys..

[Legacy777]

So I take it the crossmember was bent?

[t2402j]

So I take it the crossmember was bent?

Yup it was off by 1.5 inches..
Got the control arm in.. drove it to my house .. it runs great.. steerings ok, no shaking no pulling.