My steering rack bushings are completely shot.
Autoshop don't sell them but I found a bunch on ebay!:)
Do you guys know if they are split so I don't have to remove tie rods to slide them in, or they come in one full piece so I do have to remove tie rods to install the bushings?
Also anybody remembers whats the steering rack diameter just to make sure I buy the right stuff (sub legacy wag 92)
Thanks!
Steering rack bushings, are they split or one piece?
Moderators: Helpinators, Moderators
Re: Steering rack bushings, are they split or one piece?
Last edited by volny on Sat Aug 01, 2015 5:30 am, edited 1 time in total.
Re: Steering rack bushings, are they split or one piece?
Obviously the first two are split bushings, sorry just got done working on the car I'm tired lol
Re: Steering rack bushings, are they split or one piece?
They are split. You unbolt the mounts and the u-joint (mark where it is), slide it down, and slip the new bushings on. Not too hard as long as you get the rack down a bit and none of the bolts break off in the subframe. The fitment guide on the first ebay result for the whitelines I clicked on was not right btw.
Re: Steering rack bushings, are they split or one piece?
Thanks Jamal!
Re: Steering rack bushings, are they split or one piece?
If you're getting whiteline, you want the KSR202's.
http://www.amazon.com/Whiteline-KSR202- ... B004ZZVM8K
http://www.amazon.com/Whiteline-KSR202- ... B004ZZVM8K
Josh
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm