I'm in the middle of swapping a jdm gda sti ej207 version 7 engine and trans in to a 97 legacy outback,
I'm at the point where I'm merging the harness's together the problem is the outbacks Vehical speed sensor
Is a 2 wire and the sti is a 3 wire. How can I get this to work. I'm using the sti ecu and the trans, but using the outbacks instrument cluster. The sti's ecu will want the 3 wire is there a conversion??
Speedometer help?!!
Moderators: Helpinators, Moderators
-
- Second Gear
- Posts: 322
- Joined: Sat Mar 03, 2007 8:10 am
- Location: arvada co
Speedometer help?!!
91 SS, v9 ej207 twin scroll swap, Gda wrx dash swap.
2002 wrx sport wagon
2002 wrx sport wagon
Re: Speedometer help?!!
I posted a similar thread...
http://bbs.legacycentral.org/viewtopic.php?f=19&t=49886
From the research I've done, the actual signal going to the gauge cluster or ECU is the same, it's just how the speed sensor does that. The two wire should just have a 12v supply, and then the other end would go to the ECU & gauge cluster. The three wire has a 12v positive, ground, and signal output that goes to the ECU and gauge cluster.
That's how I believe they work....
http://bbs.legacycentral.org/viewtopic.php?f=19&t=49886
From the research I've done, the actual signal going to the gauge cluster or ECU is the same, it's just how the speed sensor does that. The two wire should just have a 12v supply, and then the other end would go to the ECU & gauge cluster. The three wire has a 12v positive, ground, and signal output that goes to the ECU and gauge cluster.
That's how I believe they work....
Josh
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm