Flywheel, Clutch, Transmission, Axles, etc...
Moderators: Helpinators , Moderators
ericem
Fifth Gear
Posts: 3242 Joined: Mon Oct 16, 2006 9:44 pmLocation: Toronto,ON Canada
Post
by ericem Mon Nov 20, 2006 12:56 am
This is between the engine and tranny on the other side i couldn't get a pic, but i see a rusted bolt on the other side, well just the thread, but the bolt seems to be broken off, with the thread sitting in it, on this side with the pic it's just a hole with threads, but no bolt, think i should put a bolt in its place? Thanks
1993 Subaru Legacy L AWD Wagon R.I.P
scuzzy
Third Gear
Posts: 775 Joined: Sun Feb 20, 2005 1:53 am
Post
by scuzzy Mon Nov 20, 2006 1:26 am
nope, that's an alignment stub. you should have two of them, one in the general area on the opposite side.
91 Legacy Wagon, Total Rally Car.
Bheinen74
Fourth Gear
Posts: 1220 Joined: Wed Feb 16, 2005 4:54 amLocation: Iowa
Post
by Bheinen74 Mon Nov 20, 2006 6:11 am
confirm, its a guide pin like mentioned above, and it might just not be that visible and could still be there.
91 Legacy Sport Sedan 4eat
ericem
Fifth Gear
Posts: 3242 Joined: Mon Oct 16, 2006 9:44 pmLocation: Toronto,ON Canada
Post
by ericem Mon Nov 20, 2006 9:54 pm
Well on the other side there is something there, buto n this side its a empty hole.
1993 Subaru Legacy L AWD Wagon R.I.P
Legacy777
Site Admin
Posts: 27930 Joined: Tue Oct 15, 2002 11:37 amLocation: Houston, Tx
Contact:
Post
by Legacy777 Tue Nov 21, 2006 7:02 pm
The alignment pins can get rusted/stuck, and can come out. So that's probably what happened.
Josh
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
206er
Fifth Gear
Posts: 2590 Joined: Wed Jun 04, 2003 4:24 pm
Post
by 206er Sat Nov 25, 2006 1:30 am
you can run one or not, doesnt really matter. there are big block v8 cars that only have 4 bolts on the bell housing.
1994 Touring Wagon: ruby mica, 5mt swapped
