knock senser

GotSubie · Post by **GotSubie** » Tue Nov 07, 2006 6:19 pm

Hey I’m trying to diagnose a fuel cut problem so took off my intake manifold just to check to make sure everything was hooked up ok. Well I was looking at the knock sensor and I noticed the connecter looks a little messed up. So my question is what should I do because Subaru doesn’t sell those connecters separately and I’m no wiring genius.

Post by **Legacy777** » Wed Nov 08, 2006 2:27 am

The connector on the knock sensor side, or the connector on the chassis side?

GotSubie · Post by **GotSubie** » Wed Nov 08, 2006 2:48 am

the chassis side

Post by **Legacy777** » Wed Nov 08, 2006 2:54 am

Hmm.....not sure what to say about that.

Imprezive · Post by **Imprezive** » Wed Nov 08, 2006 5:04 am

Cut off both male and female parts of the connector and solder in a new spade connector.

Post by **Legacy777** » Wed Nov 08, 2006 5:08 am

There is shielding in the stock cable.

Imprezive · Post by **Imprezive** » Wed Nov 08, 2006 5:19 am

But you are only taking out the connector, shouldnt you be able to bridge the shielding with some other wire?

GotSubie · Post by **GotSubie** » Sun Nov 26, 2006 4:54 am

just to let you guys know. I cut off the ecu side connecter and took it down to ralli tech and the guy there kelly just re pinned it and i sulderd it back on. idk if its gonna fix my boosting problem yet but well see.

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

knock senser

knock senser