need to know if this will fit?

RJ93SS · Post by **RJ93SS** » Wed Dec 10, 2008 3:04 am

coming from...02 wrx wagon

going on... 1993 legacy ss

SPT pink springs with Group-N tophats and Koni inserts (prefer to sell as a set!): Asking $800 for the whole shebang. Paid over $1200, total. I'll throw in the Turn-in concepts travel extenders (which I didn't end up installing) as well. Less than 15,000 km on this setup.

thanks

RJ93SS · Post by **RJ93SS** » Tue Dec 16, 2008 3:13 am

somebody has to know???

subaru_styles · Post by **subaru_styles** » Tue Dec 16, 2008 3:40 am

it will fit, however you will need different top mounts in the rear. your stock ones or GC impreza will work.

ericem · Post by **ericem** » Tue Dec 16, 2008 4:41 am

Yup, I got wrx sedan struts though on my wagon, the rear top mounts are different. Everything else works 100%. Also for the brake lines, I just tie wrapped it to the strut in a X to the brake holder spot.

RJ93SS · Post by **RJ93SS** » Tue Dec 16, 2008 8:48 pm

so if i buy this set i will not need to buy anything else?, just use my stock top mounts in the rear?

also going from a wrx wagon to a legacy sedan, will that effect ride height compared to if it was to come out of a sedan?

last question, if i don't go with this setup and i was to do more of a basic swap, could i use a specific wrx stock strut and just buy the group n top hats for the front?

sorry for all the questions, i'm just starting to learn about suspension. much appreciation for the answers!

RJ93SS · Post by **RJ93SS** » Wed Dec 17, 2008 5:22 am

RJ93SS wrote:coming from...02 wrx wagon

going on... 1993 legacy ss

qoute from seller
"SPT pink springs with Group-N tophats and Koni inserts (prefer to sell as a set!): Asking $800 for the whole shebang. Paid over $1200, total. I'll throw in the Turn-in concepts travel extenders (which I didn't end up installing) as well. Less than 15,000 km on this setup."

thanks

RJ93SS · Post by **RJ93SS** » Wed Dec 17, 2008 5:28 am

subaru dropped out of the wrc today

RJ93SS · Post by **RJ93SS** » Mon Dec 22, 2008 6:17 pm

bump, anybody?

ericem · Post by **ericem** » Mon Dec 22, 2008 7:04 pm

The front will be fine, the rear might sit a BIT higher. I doubt it though. I used sedan struts on my wagon and my car sits really good, the rear does not sag at all. Only thing I noticed was the wrx top hat made the rear sit lower, and my stock top hat makes the rear sit higher. (i still can't use wrx top hats unless i redrill the holes though). Install them though and see how the rear sits. Don't be discouraged the first time you drop the car either. It will need to settle a bit when you drive around.

RJ93SS · Post by **RJ93SS** » Sun Jan 25, 2009 4:36 am

now if the springs that come with this set are tapered in the rear then i will not be able to use my stock tophats right?

RJ93SS · Post by **RJ93SS** » Mon Jan 26, 2009 4:23 am

after doing some more research and with all of you help, i'm almost there. however, he used 04 tophats and 04 springs. any chance i can get 04 rear tophats in my car? 93ss????

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

need to know if this will fit?

need to know if this will fit?

Re: need to know if this will fit?

Re: need to know if this will fit?