legacycentral bbs

I just read the whole Rob Tune thread and decided to put the PP6 into the Brat so I can get used to it before I do the turbo swap in it.

But I changed my mind again on stroking the engine! (This is getting irritating)

I'm now pretty much just going to stroke it if Rob says his tune is able to handle a stroker motor.

I inspected the crank and it needs some machining before it can go back in. I'd rather put a good one in than machine the crank. So I'm going stroker if the tune can do it and staying the same if it cannot.

Rebuilt the rods and turned the crank, meanwhile bored the block out and have the bottom end completed.

Need to put on the heads and start putting things together.

[/URL]

[/URL]

[/URL]