legacycentral bbs

How it sits today! 3/21/12
I'll try to get some better shots soon.

Playing in the mud is always fun

I replaced the passenger side fender this past weekend. The one I took off is going in for surface rust repair..


Also test fit flaps today.

I like the look.

I'm going to install them tomorrow!

I replaced my front seats with RS fronts this past weekend! Had them in the 92 as well. Now onto the 94
they need a bit of cleaning....but other then that they are in good shape.








also got the flaps actually installed last weekend

Nice Ti!

I gotta ask, was the air suspension tits up? Or did you just want the reliability of normal struts?

^ Sorry it took so long for a reply!!! The air suspension was complete crap... and yest the reliability of the normal strut/spring was a definite plus...


I've got some new tires for the LGT rims! should have them on next week




and found a neat little hide out in the local woods so I figured I'd snap a couple pictures while there.

Now Clean with re-sprayed wiper arms and steelies.









.......and now for some night shots! I'm such a pic whore.

Changed the steelie color from primer grey to flat white. I like it better.

Looks good how did u attach the flaps

Thank you.

I used speed clips and screws.... I used nuts and bolts on my wife's red LGT in front of mine

Where did u get the flaps

I got them from Ballistic Motorsports. http://www.mainelysubarus.com/forums/to ... ne-gaurds/.. I had to call them to order. They have a variety of different colors are hard plastic and rugged as hell

Can I get the number

So I keep having issues with my throttle sticking a bit... about fifteen to seventeen hundred rpms... I've noticed that when it is sticking (the plate and screw in picture) aren't touching ... So I've PB Blasted the shit out of all the springs and it still sticks... where can I go from here??

I adjusted the throttle cable just a bit and it seems to be better.. we'll have to wait and see..

also yesterday I cleaned out the throttle body.. It wasn't all that dirty. hopefully these couple of things will keep it from sticking.


Can you get new springs for the throttle body?

Not really. It'd be easier just to pick up a used throttle body.

I actually have a used one from my old engine. I should just transfer it over eh.. see where that gets me.

Why not remove the throttle body and take the springs off and wire wheel them really good, get all the rust and corrosion off and clean the throttle body and TPS and stuff and lube it up with some lithium grease and reassemble? Make sure it spins easily by hand after it's all cleaned up before you put it back on.

^^ good point.....


On another note....

I got eight pieces of aluminum. each 23.5 long and 15.5 wide. I need to fabricate skid plates NOW!


Does anyone have any info/specs of their own skid plate that I could use as a template???

I would measure mine but it recently got killed while I was wheeling. I may still be able to measure it a bit though.

sweet. I'm on another forum (Mainely Subarus) and someone posted this up but it's for a GD impreza. So I'm not sure how close it is.

Got a bit of bodywork done on the Legacy today. Managed to dodge the rain clouds as well.

The color match doesn't quite match up but ah well....Sorry for the HUGE pictures..

Well the roof of the legacy got some much needed love yesterday! Scraped/Sanded/Primed/Plasti-Dip.