Boost Gauge install...
Posted: Fri May 10, 2002 4:27 am
Just got a boost gauge and am ready to install it. I
was just wondering where everyone's installed theirs?
I was thinking on the top left side of the dash, but I
don't want to permanently mar the surface of the dash.
Any suggestions? Or better yet, pictures?
Oh, and Dave, I've seen where you mounted yours on the
steering column. Very nice, but again, I'd like to do
something that doesn't leave anything permanent if
possible. I've also considered the DIN replacement,
or even making my own DIN panel for the gauge, but I'm
not sure what other gauges I'd get to fill the other
potential slots.
I'm also considering trying to get a Saab 900
intercooler in there but am worried about the cost of
getting the piping fabricated. Has anyone here added
a non-Subaru I/C with any luck? I'm trying to keep
the cost down otherwise I'd find a used Subaru piece.
I know that no matter which route I go I'll have to
have some piping fabricated. Any suggestions on where
I could turn to have the tube/piping fabricated?
TIA.
-Brian
__________________________________________________
Do You Yahoo!?
Yahoo! Shopping - Mother's Day is May 12th!
http://shopping.yahoo.com
------------------------ ---------------------~-->
Buy Stock for $4
and no minimums.
FREE Money 2002.
http://us.click.yahoo.com/orkH0C/n97DAA ... /XoTolB/TM
---------------------------------------------------------------------~->
To unsubscribe from this group, please send an email to:
BC-BFLegacyWorks-unsubscribe@egroups.com
was just wondering where everyone's installed theirs?
I was thinking on the top left side of the dash, but I
don't want to permanently mar the surface of the dash.
Any suggestions? Or better yet, pictures?
Oh, and Dave, I've seen where you mounted yours on the
steering column. Very nice, but again, I'd like to do
something that doesn't leave anything permanent if
possible. I've also considered the DIN replacement,
or even making my own DIN panel for the gauge, but I'm
not sure what other gauges I'd get to fill the other
potential slots.
I'm also considering trying to get a Saab 900
intercooler in there but am worried about the cost of
getting the piping fabricated. Has anyone here added
a non-Subaru I/C with any luck? I'm trying to keep
the cost down otherwise I'd find a used Subaru piece.
I know that no matter which route I go I'll have to
have some piping fabricated. Any suggestions on where
I could turn to have the tube/piping fabricated?
TIA.
-Brian
__________________________________________________
Do You Yahoo!?
Yahoo! Shopping - Mother's Day is May 12th!
http://shopping.yahoo.com
------------------------ ---------------------~-->
Buy Stock for $4
and no minimums.
FREE Money 2002.
http://us.click.yahoo.com/orkH0C/n97DAA ... /XoTolB/TM
---------------------------------------------------------------------~->
To unsubscribe from this group, please send an email to:
BC-BFLegacyWorks-unsubscribe@egroups.com