Page 1 of 1
Anyone have a Legacy Turbo Exhaust Schematic/Plan??
Posted: Fri Dec 26, 2003 8:28 pm
by LegacyT
Well, I think I will be upgrading my exhaust soon to a 2.5/2.75 catt-less turbo back system. Anyways I found a local shop that will do it for a good price. I'm wondering if anyone has a plan or schematic whether on paper or on file they are willing to show me. One that shows measurements, bends etc. Since this would save me the money and time of leaving my car there and paying for them to remove, measure build and reinstall the exhaust. Ideally I'd give em the plans, have them make it, pick it up, and install it myself.
Thanks,
Mark
Posted: Mon Dec 29, 2003 6:44 pm
by totech
Mark,
Brullen here in Toronto has it all made up....
That is what I am running header back..
Posted: Tue Dec 30, 2003 12:33 am
by LegacyT
Is that the guy selling the 2.25 inch systems on the tsc forum? I think his name is Do it sidewayz? I'd get one from him but they aren't mandrel bent. I also would like larger diameter tubing like 2.75 inch, possibly
Mark,
Posted: Tue Dec 30, 2003 2:45 am
by totech
No Mark, This is a real exhaust company only.
Brullen -
I have their 3" turbo back
Posted: Tue Dec 30, 2003 2:48 am
by LegacyT
Bolts right up to the legacy turbo, no mods at all? How much? what are the specifics of the system?
Mark
Posted: Tue Dec 30, 2003 3:08 am
by totech
Brullen is mandrel bent.
It is bellmouth... high flow cat, two resonators and one dual tip muffler.
Installed with a new up-pipe was just north of 1K
Posted: Tue Dec 30, 2003 3:09 am
by totech
Oh yeah, stainless and lifetime warr.
Posted: Tue Dec 30, 2003 3:12 am
by totech
Posted: Sat Jan 03, 2004 2:21 pm
by LegacyT
Hey totech,
How did you get ahold of brullen? Did you get your exhaust done through a local dealer or strait from them? I fired them an email last week, stating my request and havn't gotten a reply.
Mark,