Torque spec and order
Posted: Wed Jul 09, 2003 9:58 pm
For heads on 90 2.2.
thanks
thanks
From '91 service manual:
looking @left side of engine bolts left to right and top to bottom are numbered:
3 - 1 - 6
5 - 2 - 4
-tighten all bolts in order to 22 lbs/ft
-tighten all bolts to 69 lbs/ft
-back off all bolts 180 deg, then back off another 180
-tighten bolts 1 & 2 for non-turbo to 25 lbs/ft (turbo to 27.1)
-tighten bolts 3, 4, 5, 6 for non-turbo to 11 lbs/ft (turbo to 14)
-tighten all bolts by 80 to 90 deg in numerical sequence (do not excede 90 deg)
-further tighten bolts by 80 to 90 deg in numerical sequence
-total retightening angle should not excede 180 deg.
Steve.