legacycentral bbs

ok, i mounted it up right under the bummper beam but when i tried to put it all back together the skid plate is about 2.5 inches above the bottom of the bumper skin and pushes the intercooler out 2 inches to much so that it the it doesnt clear the bumper cover. somehow this cant be right and im asuming that it has someting to do with my fender bender.

so my question for you is, can one of you take a picture of the front of your car up close and personal to the lower grille? i need to see if its just my car thats like this.

and along with that is it safe to cut the skid plate down to size?

a picture with everything on there? if so, no problem

yeah everything on there.

brb

and no that damage is NOT from me, though there's a nice pool in my passenger side corner lense

Poor bumper

thanks laurel. but is it possible to get into the grille looking down onto the inside bottom where the skidplate is suposed to meet the bumper cover. if that doesnt make sense lemme know

and if it makes you feel better my bumper looks like that too. cept a little worse

My rear one is starting to look like that too