Page 1 of 1
Pics of the piping
Posted: Mon Nov 22, 2004 9:13 pm
by dzx
Let me know if the link doesnt work.
It's dirty, It's messy, It gets the job done. I need to clean up my engine bay a little more. The sun was in a bad position where i parked but i'll take some better pics later let me know if there is a specific spot you want to see.
http://www.cardomain.com/memberpage/641778/6
Oh yeh, ignore the duct tape on the coffee cup
Posted: Mon Nov 22, 2004 9:30 pm
by legacy92ej22t
Looks good! I wanna see a front end shot though too.
Posted: Tue Nov 23, 2004 4:24 am
by azn2nr
and one of the passanger side where the pipe goes down into the front. and passanger side in general.
whats your pipe size and is it crush or mandrel or a combination of both.
Posted: Tue Nov 23, 2004 4:33 am
by jake15
looks good, where did you get the silicone couplers and how much? where'd you get the pipes? did you do any welding? thats all the ?? i can think of for now....
Posted: Tue Nov 23, 2004 5:35 am
by dzx
The silicone i got from an RV/Truck store. It was 20 dollars a foot. The piping is 2.5" and is mandrel bent, all of it. The pipes i bought off of ebay aluminum bends were 20 dollars each, 5 foot section of stainless steel was 33 dollars but shipping was expensive and i never did get the other 5 foot section i ordered. I didn't do any welding because i dont have a welder for aluminum or stainless steel and the couplers hold it just fine. I'll take those pics sometime tomorrow.
Posted: Tue Nov 23, 2004 6:22 am
by ultrasonic
all work and no play make jack a dull boy.
Props to Jack and Stanley.
Posted: Wed Nov 24, 2004 12:39 am
by dzx
pics are up
Posted: Wed Nov 24, 2004 5:27 am
by azn2nr
deng you have the small abs