legacycentral bbs

For some reason I can't find the stupid thing.

I need to remove the clutch fork to seperate the engine and tranny right? It's on the driver side isn't it?

Is it behind the plate where the clutch line attaches? Do I have to remove that plate to get to it or something?

I need help.

Oh, also, what size hex is it, anyone know? I hope it's 10mm because that's the biggest one I have.

TIA

I'm pretty sure it's 10mm hex.

Yeah, it should be on the driver side... We both saw it up close on the boostjunkie tranny...

Look at the third picture on this page:

http://www.legacycentral.org/library/tr ... _trans.htm

It's the little plug right by the starter hole, right? So maybe you need to remove the starter if you haven't already?

Aha! I couldn't remember exactly where it was when were pulled the BJ engine. I haven't uhooked the starter yet so that's why I couldn't find it! Hehe, thanks V!

No problem. Good luck.