Page 1 of 1
I just got my Downpipe
Posted: Wed Mar 16, 2005 11:13 pm
by TDGKORN
I got the helix one, because it has two O2 bungs (one for stock and one for wideband)
I have secret plans for the exhaust
Troy
Posted: Wed Mar 16, 2005 11:29 pm
by jake15
if you have a AT that downpipe will hit the tranny ( at least it did one mine). I had to put a small dent in it so it will fit
but it works fine. its a great downpipe though.
Posted: Wed Mar 16, 2005 11:30 pm
by TDGKORN
Which part of it hit
Posted: Thu Mar 17, 2005 5:58 am
by BAC5.2
Why are you using 2 O2 bungs?
Why not use just the wideband? If your plans involve SEM, the unit you choose should be able to run with the wideband reading.
Posted: Thu Mar 17, 2005 3:44 pm
by TDGKORN
I will be getting the E-manage and It can be set up to run my stock 02 sensor, but it is easier to leave it. Plus wideband sensors don't work very well at exh. temps above 800 degrees, so the bung closer to the lower cat. is a better place for it.
Posted: Fri Mar 18, 2005 7:30 am
by jake15
i think it hit near the corner of the pan on the bottom of the tranny, but i dont quite remember. next time i have my car up in the air i can take a picture for you.
Posted: Fri Mar 18, 2005 7:52 am
by azn2nr
heh my exhaust hits that part of the tranny too. i didnt have to put a dent into it and figured that it was so tight against the pan that it wouldnt rattle but low and behold when its in gear it rattles. now i have to get a silicone couppler to dull the rattle.
Posted: Fri Mar 18, 2005 4:32 pm
by TDGKORN
Thanks for the heads up.
If I think of it I will take some pics when I install everything.