Page 1 of 1
P/B control units, different ones apparently?
Posted: Wed May 25, 2005 9:54 pm
by kidwired
I just bought a control unit on ebay
it looks different than mine.
Mine is the green plastic box pn #88013AA060
auction said it fit 90-94 Legacy.
I dont have the pn for it yet, heres a pic
Hope it works!
Posted: Wed May 25, 2005 10:51 pm
by IronMonkeyL255
Mine (from a '91) is a p/n 88013AA041.
Mine is metal, too.
Don't now if that helps any.....
Posted: Fri May 27, 2005 4:52 am
by Legacy777
remind me tomorrow.....I'll look in the parts book, and see if the different controllers have been superceeded by the newer part #'s.
Posted: Fri May 27, 2005 6:05 pm
by tris91ricer
I'd think they were compatible/intechangeable. I only replaced the driver's side belt/rail assembly all the way down to the solenoids, as well as a computer from a 91 L. All belts work flawlessly..
Posted: Sat May 28, 2005 4:38 pm
by kidwired
sounds like it could work.
Legacy777- checking P/n's might help me sleep better
I took my controller apart hoping to find an ez fix, like broken solder but no luck. I'm just not good enuff w/ electronics to figure out whats wrong.
Posted: Sat May 28, 2005 5:09 pm
by Legacy777
What you bought on ebay is the p/b controller for the station wagons. Since you have a sedan, the controller is in a different box.
I don't know if the internals are the same.....they probably are.....but it won't mount up the same as the sedan ones.
Posted: Sun May 29, 2005 2:17 am
by kidwired
thanks josh, maybe I can mount the pb board in my box. Guess I'll see, theres always zip ties!