WRX Hood Scoop Fitment Idea/Question
Posted: Sun Sep 18, 2005 5:55 am
I was just kinda browsing around the boards, and thought of a few ideas, and wanted to run them across you all first.
On the fitment of a wrx hoodscoop, which I know has been discussed several times before on here....
I was thinking.....put the scoop on the hood, measure, drill holes, then feed the screw moutning points underneath the scoop through the drilled holes, and you put a nut underneath it, bam you are done.
or is that to easy
I read about rivets and such but then it will be harder to remove, that and with the pre screws already on the scoop its already flat and smooth on top of the scoop, no screw heads showing.
I am assuming this to be done on a NA hood, with a scoop hole already cut BTW.
But will that work, the screws should feed through and press the scoop flat up against the hood, and make it look just as clean.
3M tape is not good, nor will it hold the scoop flat.
What do you all think?
David
On the fitment of a wrx hoodscoop, which I know has been discussed several times before on here....
I was thinking.....put the scoop on the hood, measure, drill holes, then feed the screw moutning points underneath the scoop through the drilled holes, and you put a nut underneath it, bam you are done.
or is that to easy
I read about rivets and such but then it will be harder to remove, that and with the pre screws already on the scoop its already flat and smooth on top of the scoop, no screw heads showing.
I am assuming this to be done on a NA hood, with a scoop hole already cut BTW.
But will that work, the screws should feed through and press the scoop flat up against the hood, and make it look just as clean.
3M tape is not good, nor will it hold the scoop flat.
What do you all think?
David