Page 1 of 1
at to mt pedal swap !!!!HELP PLEASE!!!!
Posted: Thu Oct 06, 2005 6:07 pm
by poseidon1787
i pulled the tranny from my at front wheel drive and am getting ready to put my MT tranny in, i need to know , are there holes for the MT pedals in my AT legaacy, or will i have to drill new ones? i have searched but found no specific info on the installation of the pedals i need all the info i can get please help!!
Posted: Thu Oct 06, 2005 8:07 pm
by gt2.5turbo
there should be a diamond shaped rubber gromet on the firewall that is made for the clutch i believe. other than that everything elses should go through the holes already there.
Have you read the write up on the awd/mt swap? it is very very helpful
Posted: Fri Oct 07, 2005 1:59 am
by THAWA
What year is your car, and what kind fo pedals are you putting in? If it's hydraulic and your car is the first gen you don't have the holes for it. If it's cable you have a hole for it, it's kinda hard to see from the engine side, but you should be able to see the grommet from the interior side.
Posted: Fri Oct 07, 2005 5:17 am
by entirelyturbo
THAWA wrote:If it's hydraulic and your car is the first gen you don't have the holes for it.
You mean if it's a 1990 only
91-94's had turbos so they had the holes for the hydraulic setup...
Posted: Fri Oct 07, 2005 5:38 am
by scuzzy
subyluvr2212 wrote:THAWA wrote:If it's hydraulic and your car is the first gen you don't have the holes for it.
You mean if it's a 1990 only
91-94's had turbos so they had the holes for the hydraulic setup...
even the NA's had the holes for the hydraulic setup?
so it's just a matter of switching over to the new pedal setup and clutch slave system?
Posted: Sun Oct 09, 2005 4:53 am
by Legacy777
Yes...the holes are there.
Also....please post in the correct forum!
Posted: Tue Oct 11, 2005 4:04 pm
by THAWA
Show me one FWD 1st gen Legacy that has hydraulic clutch holes. Hell, show me any non-turbo 1st gen Legacy with hydraulic clutch holes.
Posted: Tue Oct 11, 2005 6:33 pm
by 206er
what do they look like? curious to see if mine has em.
Posted: Wed Oct 12, 2005 2:11 am
by Legacy777
THAWA wrote:Show me one FWD 1st gen Legacy that has hydraulic clutch holes. Hell, show me any non-turbo 1st gen Legacy with hydraulic clutch holes.
Are you talking about the holes to mount the clutch MC?
They should be there from 91 onward.
Posted: Wed Oct 12, 2005 2:13 am
by Legacy777
206er wrote:what do they look like? curious to see if mine has em.
These are the holes, it will have a single rubber plug over all three holes.
http://www.surrealmirage.com/subaru/ima ... P_3242.JPG
Posted: Wed Oct 12, 2005 3:21 am
by THAWA
Yep those are the ones that are absent on all NA first gen legacys. I think they weren't standard on all subarus until 98 or 99.
