Page 1 of 1
after swap it wont start!!! HELP!!!
Posted: Tue Oct 18, 2005 7:48 am
by poseidon1787
i am in the process in an at to mt swap on a 91 legacy front wheel drive, we bolted the tranny into place and connected the starter ,the intake is hooked up,when i go to start it , it doesnt make any noise it doesnt even try to turn over. any help would be great
Posted: Tue Oct 18, 2005 8:05 am
by douglas vincent
dead battery?
Seriously.
But then again, just check for power to the starter.
Also, there is a kill switch on MTs that need to know that the clutch is engaged. I killed mine once on amotor pull and freaked myself out for aminute. Then I just bypassed it and it started right up.
Posted: Tue Oct 18, 2005 6:14 pm
by Legacy777
Did you do any of the wiring stuff yet? You didn't make any mention of that.
Have you read my write up?
no wiring done
Posted: Wed Oct 19, 2005 1:31 am
by poseidon1787
no i havent messed with ne wiring yet and how do i bypass that mt safety switch???
Posted: Wed Oct 19, 2005 6:12 pm
by Legacy777
Jumper pins 11 & 12 together on the B15 AT connector.