How to set deflection
Ok, take this map
(right click and save)
http://www.vincentfurniture.com/photos/ ... asemap.SMT
, and clear out to 0 all the numbers in the ignition and
analog maps. This will give you a "zero" map. Save this map as "Zeromap"
When you save it, you have the opportunity to change the map name. Do it
to "Zeromap", makes it easier to find later.
Now take your laptop to your car and hook it up. Have the laptop turned on
and the software running. Turn the key to ignition on. Now load the
"Zeromap" When you load, at the top of the window, there will be an option
to "download" the map to the SMT6. Make sure this is checked. Load map.
OK, the map is now in your SMT6. Now you need to set deflection.
Keep the key in the ignition on, motor off, phase.
Press the gas pedal. You should, if your TPS wire is wired in correctly,
the cursor go from right to left across the bottom of the map. Make sure
the map is in the analog (cause thats what I am referencing).
What are the numbers when the pedal is fully out? (mine was 18ish)
What are the numbers when the pedal is floored? (mine was 95ish)
Now go to option "Scale Settings" and choose "Deflection"
You will be able to set the "Min" and "Max"
Click "activate function"
Set min to +5% of the low number you had
Set max to -5% of the high number you had
click "apply"
Click "OK".