Page 1 of 1
WRX SUSPENSION
Posted: Mon Dec 12, 2005 7:56 pm
by Legacyturboguyin253
Will a 04 WRX complete suspension work in my 94 SS?
And what would i need to modify to get it to work?
Posted: Mon Dec 12, 2005 8:03 pm
by vrg3
See where it says "legacycentral bbs Forum Index -> Suspension" above your post?
Click on "Suspension."
Then click on the very first thread you see.
Posted: Tue Dec 13, 2005 2:56 am
by jamal
my post on the last page of the compendium explains things nicely I think.
Ok
Posted: Tue Dec 13, 2005 6:48 pm
by Legacyturboguyin253
Ok Im getting a STI suspension so thats gonna be a interesting project!!! I hope it goes smoothly!!!
Posted: Tue Dec 27, 2005 7:33 pm
by Imprezive
The rear top mounts wont fit. You'd have to buy some STI Group N top mounts for a GC8 for the rear.
Posted: Thu Jan 12, 2006 4:39 am
by dzx
I used the stock rear hats with my tein springs and wrx struts.
Posted: Thu Jan 12, 2006 6:32 am
by scottzg
vrg3 wrote:See where it says "legacycentral bbs Forum Index -> Suspension" above your post?
Click on "Suspension."
Then click on the very first thread you see.
and i dont even have to sarcastically pimp the compendium.
:hugz: to the bbs.
Posted: Thu Jan 12, 2006 6:54 am
by Legacyturboguyin253
I installed 04 STI struts with Tenabe Lowering Springs.
Posted: Thu Jan 12, 2006 7:38 am
by Psychoreo
anddd....... how did it fit/how do they feal? also recheck the compendium and if it's not covered, post it there
Posted: Thu Jan 12, 2006 9:21 pm
by Legacyturboguyin253
It fit perfect and cost 80$ for install and 195 for the springs and the suspension was free because it came out my dads STI.
And i like it alot it is firm. It lowered it nicely the front is lower than the GC 2.5 RS strut and spring set up on the Legacy turbos and the rear a a tad bit higher than the 2.5 rs GC setup on the Legacy. Im gonna cut the springs to lower the rear.