legacycentral bbs

So I decide to finally replace my burnt out backlights for the instrument panel. The first step of this process is taking out the large trim panel in the dash. I pry out and unplug the switches and controls for the defrost and rear view mirror control, but ended up going for a drive without remembering to plug them back in.

Now my right headlight's low beam is burnt out and my turn signals don't work whatsoever. I'm sure the headlight just needs a new bulb, but I've checked every fuse that seems remotely relevelent and they're all good. I move the turn signal arm and it makes not a sound. Ack! What should I do next? I'm terrible at diagnosing electrical problems.

plug in the hazard switch. yes I am that good

Plug in the harness for the turn signals...yes I am that much better.

subawhatsubawho wrote:Plug in the harness for the turn signals...yes I am that much better.

uhumm its not the turn signal harness young grasshopper. that would not be disconnected in removing the dash panel. Only the hazard switch would be unplugged doing so.

p.s. I'm not really this much of an ahole, its the beer talking...

Shhhh......He might have unpligged it.

Success!! It was the hazard light. Works like a charm. Thanks again everyone!

Fugazi wrote:Success!! It was the hazard light. Works like a charm. Thanks again everyone!

uh huh! your welcome.

Please hold you applause....I will be signing autographs at the end of the show. (Mike asked me how to fix the problem then posted the answer. I was too busy in the ashtray.)

subawhatsubawho wrote:Please hold you applause....I will be signing autographs at the end of the show. (Mike asked me how to fix the problem then posted the answer. I was too busy in the ashtray.)

...no you didn't!

Magic Mike cut the record show me how ya get down!!

I still like speaker terror upper. With the tit tit tit and the boom de boom boom....

Happy new years guys....and gals.!!!