Page 1 of 1
Someone might like this...
Posted: Thu Mar 09, 2006 3:48 am
by BAC5.2
http://cgi.ebay.com/JDM-SUBARU-IMPREZA- ... dZViewItem
Pretty good deal too.
Same turbo I have minus the porting and polishing.
Posted: Thu Mar 09, 2006 5:26 am
by dwreck30
I've been looking at those, but I thought that they would'nt fit because elbow hits the intake. Correct me if I'm wrong because I'd like to get one.
Posted: Thu Mar 09, 2006 5:36 am
by legacy92ej22t
You're wrong.
It's the newer IHI turbos and stuff that have the straght inlet, for the newer Subie turbos, that cause you to hit the intake manifold when trying to plumb them in. The TD05H-16G practically drops in. There are some modifications that need addressed, like the PCV lines and the compressor outet plumbing. Those are easy fixes though.
Posted: Thu Mar 09, 2006 7:44 am
by dwreck30
Sweet, so what would be the point in getting one from Deadbolt w/ the clocked housing when using a WRX TMIC?
Posted: Thu Mar 09, 2006 1:21 pm
by legacy92ej22t
If you're going to use a MY02-MY05 WRX TMIC then it's better to get the regular version and not the clocked. That's what I have, a non-clocked, Deadbolt Monster 16G with full ceramic coating. I highly recommend.
Posted: Thu Mar 09, 2006 4:41 pm
by LaureltheQueen
i have a 16g that I pulled from a 95wrx engine. fit in perfectly with the exception of needing to re-plumb my entire pcv system