legacycentral bbs

I have both turbos from a twin turbo engine, the engine appeared to have very low miles. I think the engine is the second model ej20h with the matching turbos, they are IHI RBH(?) 4 = 5+5 on the compressor side and 9 on the exhaust side. I also have some of the outer components from the engine, the intake pipe is broke and I sold the manifolds and up pipes. Have some sensors etc.
Western WA

Would to mind taking some measurements of the inlet/outlets on the compressor and turbine? Also the number of blades? and any visible numbers on the compressors or turbines? Thanks!

Primary
IHI RHF4
Intake = 5+5 fins Exhaust = 9 fins
various casting marks
K1
6B
4H
T
10
6320
Markings on band
73.0
6A2 04H
Air in 1.55"
Air out 1.15"
Ex in 1.3"
Ex out 1.45

Secondary
IHI RHF4
Intake = 5+5 fins Exhaust = 9 fins
S3003
Markings on band
73.0
SC3 04H
Air in 1.55"
Air out 1.15"
Ex in 1.3"
Ex out 1.45"

Let me know if you need anyhting further and any insight you can share would be consdered helpful.

It's been a while Mark!

You going to be kickin' some ass at OTR?

NW Boxerwerks is gonna be out in force!!!

Well pending shakedown, the car is running and seems to run good. I still have some other work to do but should make OT.

A week or so back a guy on NASIOC was trying to source these turbos. He started a thread in the Pre-2002 factory turbo forum. Maybe you can track him down and sell these to him...

Do you have the harness?

Thanks Matt, I'll check over at Nasioc.

BalckBart, I have the harness. $300

The exhaust is sold, still have the turbos in very good, low mileage condition. One of these might be just the trick for a Justy