legacycentral bbs

Dont see what all the fuss is about. Went together pretty smoothly.

Theres still a couple more lines I have to route, and the water isnt plumbed yet, but all the intake is hooked up.

What did you use do connect the turbo to the AWIC inlet? (Can you take a closer picture of that area)

I am guessing that your car has an automatic tranny, if not how much clearance do you have between the AWIC intake tube and the master clutch reservoir?

And what are you doing to support the AWIC?

I fabbed up a piece of mandrel bent stainless steel. I cant take a picture because its not in my car anymore.
My car has a manual tranny, and it was pretty much resting on the master.
Im going to bent up some steel stock with some eyelets welded on and bolt it to the intake manifold.