Page 1 of 1
Little Help Please? Hose question...
Posted: Thu Oct 05, 2006 11:28 pm
by nicfunkadelic
I am reassembling an ej22t hybrid in my 99 RS, and I'm hoping with you guy's help she can run again soon.
Under the intake manifold, basically front cener of the motor, slightly to the left there is a hose fitting that comes up out of the crankcase, and bends 90 degrees towards the front of the car...
I have the manuals, and have read them for hours, and searching hasn't given me much.
Thanks agan,
Nick
Posted: Thu Oct 05, 2006 11:45 pm
by Bheinen74
yep. On a EJ22T motor, and maybe all, that 90 degree elbow attaches to a "T" fitting, and one side of the T goes to the right valve cover, the other side goes to the left valve cover. hope that helps.
Posted: Fri Oct 06, 2006 2:35 am
by scuzzy
If you're feeling froggy and don't have the plastic piece which connects the valve covers to the crankcase, you can block this off, I've been going a year so far without it, no problems.
Posted: Fri Oct 06, 2006 4:24 am
by nicfunkadelic
Interesting... I'm actually using my 99 RS SOHC heads, so no stock nothing for me. I think the Legacy heads had 2 hose fittings on each cylinder head, is that right? the RS heads only have 1 per head, and go back by the throttle body..
Posted: Fri Oct 06, 2006 4:36 am
by Bheinen74
pretty sure my legacy ej22t only have one hose per valve cover, and i do KNOW that the drivers side head/valve cover hose goes up, around/under/by the coolant tank, then frontward towards the intake, then it bends up towards this 90 degree elbow and t fitting behind the power steering pump/alternator.