Page 1 of 1
Should there be a bolt here? /PIC\
Posted: Mon Nov 20, 2006 12:56 am
by ericem
This is between the engine and tranny on the other side i couldn't get a pic, but i see a rusted bolt on the other side, well just the thread, but the bolt seems to be broken off, with the thread sitting in it, on this side with the pic it's just a hole with threads, but no bolt, think i should put a bolt in its place? Thanks
Posted: Mon Nov 20, 2006 1:26 am
by scuzzy
nope, that's an alignment stub. you should have two of them, one in the general area on the opposite side.
Posted: Mon Nov 20, 2006 6:11 am
by Bheinen74
confirm, its a guide pin like mentioned above, and it might just not be that visible and could still be there.
Posted: Mon Nov 20, 2006 9:54 pm
by ericem
Well on the other side there is something there, buto n this side its a empty hole.
Posted: Tue Nov 21, 2006 7:02 pm
by Legacy777
The alignment pins can get rusted/stuck, and can come out. So that's probably what happened.
Posted: Sat Nov 25, 2006 1:30 am
by 206er
you can run one or not, doesnt really matter. there are big block v8 cars that only have 4 bolts on the bell housing.