legacycentral bbs

I need the black plastic bend that goes on the turbo's inlet. This is the piece that has the crankcase and valve cover breathers connect to it, as well as our stock diverter valve. Mine has a big cut in it, where the diverter valve hooks up, so non-metered air can enter here, and make my car run rich. I could just JB-weld this up, but I would much rather fix this the correct way.

Thanks

--mark

i got one, pm me an offer

ok i remember now, mine has a hole in it, but it has been repaired with a brass valve, still works, but not factory