Bosal Twintip Catback installed
Posted: Mon Apr 02, 2007 10:53 pm
So ive been trying to figure out logistics on the extension pipe to use this 3" system for a while now. Finally sat down and made some calls and got some raw universal 3" 2-bolt flanges and 6.25" of pipe. Had a local MNSubaru club member who owns a Meinake expand the ends to fit the flanges. Rest was just weld, bolt on, and use excessive rtv just incase. Figure the welds didn't turn out half bad for not having used a welder in ages and only flux core.
Pictures are here
Sounds great, a smidge loud at times but nothing excessive. Fitment was a little quirky. Had to bend the drivers side axleback hanger in so it would pull as far drivers side as possible. Otherwise it hits the rear diff carrier. So let me know what you guys think. Anyone else thrown one of these up on theirs?
Pictures are here
Sounds great, a smidge loud at times but nothing excessive. Fitment was a little quirky. Had to bend the drivers side axleback hanger in so it would pull as far drivers side as possible. Otherwise it hits the rear diff carrier. So let me know what you guys think. Anyone else thrown one of these up on theirs?