Page 1 of 1
IC Hose
Posted: Sat Jun 02, 2007 6:16 pm
by scoobydude
Well I decided not to be ghetto like i planned and i went and ordered some silicone IC hose from siliconeintakes.com. They seem to be good quality and they look nice. I think i paid less than 20 for the 90 degree elbow and the local store wanted 70 for one. Not too bad of a savings!
Posted: Sun Jun 03, 2007 1:45 am
by thehookeup
i think that looks great. hows it working for you. and what arre you doing about a blv? recirculating i assume?
Posted: Thu Jun 07, 2007 1:42 am
by Imprezive
good job not being ghetto.
The only thing less ghetto would be to have an aluminum pipe welded up to custom fit and only 4 clamping locations instead of 6.
Posted: Thu Jun 07, 2007 6:53 pm
by scoobydude
well i would of done that but for what i had to do none of the muffler shops around here were able to do that. seeing that i had to make such a sharp 90 degree bend with it reducing from 2"1/2 OD to 2" OD. Ill see if i have any pictures of it before. This is more than an upgrade.
Posted: Sun Jun 17, 2007 7:06 pm
by boro
I was just fiddling with mine this morning. I had to flare cut a Nissan CA18DET rubber IC pipe for the bend. Then I used a 2" OD - 2 1/2" OD reducer to clear the gap from the elbow to my BOV hard-pipe. 4 clamps for me
