legacycentral bbs

i want to know if i can put a pedal box from another subaru to my 1991 legacy ???

It should work providing it is:

A) of the same clutch release type (unless you are converting)

B) cable throttle (unless you are converting to throttle by wire-in which case I wish you good luck)

thank u
i'll check this out

555BCTurbo wrote:It should work providing it is:

A) of the same clutch release type (unless you are converting)

B) cable throttle (unless you are converting to throttle by wire-in which case I wish you good luck)

Would the throttle type even matter? The throttle pedal is on its own assembly separate from the clutch/brake assembly in cable-operated applications. Did they integrate the units for throttle-by-wire cars?

IronMonkeyL255 wrote:

555BCTurbo wrote:It should work providing it is:

A) of the same clutch release type (unless you are converting)

B) cable throttle (unless you are converting to throttle by wire-in which case I wish you good luck)

The throttle pedal is on its own assembly separate from the clutch/brake assembly in cable-operated applications.

Same thing with hydro setups. I swapped to a SS hydro without toutching the throttle.

That's a damn good point...

I don't know why on earth I thought that the throttle pedal was part of the cluster...especially because I did a 4eat > 5mt swap a few months ago...

A couple of the bolts from a WRX pedal box won't match up but it's no big deal. Yo should be good to go providing you follow 555BCTurbo's other advice.