Page 1 of 1
FS: EJ20 cross member
Posted: Wed Aug 15, 2007 7:37 pm
by adema2626
Thought some one on here might want this fairly cheap price, its not mine.
http://cgi.ebay.com/ebaymotors/JDM-Suba ... QQtcZphoto
Posted: Wed Aug 15, 2007 10:25 pm
by 86ruguy
Sooooooo, this IS needed to do the EJ20G swap into my 5mt wagon?
Somebody please advise.
TIA,
Dave
Posted: Wed Aug 15, 2007 10:31 pm
by gto7419
If you have a non turbo cross member and you are putting in a turbo motor, you need a turbo cross member
Basically, if you have an n/a car, you need this or one similar...
Posted: Wed Aug 15, 2007 10:35 pm
by adema2626
but you half to have a 95 and up legacy for this to work. Because im pretty sure in 95 they made the width of theses bigger or something so it doesn't work on earlier legacy's.
Posted: Wed Aug 15, 2007 10:36 pm
by 555BCTurbo
adema2626 wrote:but you half to have a 95 and up legacy for this to work. Because im pretty sure in 95 they made the width of theses bigger or something so it doesn't work on earlier legacy's.
No dice...
They's the same width
That particular crossmember is out of a Twin Turbo car, however...and I am not 100% sure on the compatibility with our LHD, Single Turbo cars...
I'm sure someone knows
Posted: Wed Aug 15, 2007 11:18 pm
by 86ruguy
Okay, thanks for the info and will check to see if it will work on a LHD car. If not I will just have to do something else.
CUTTING TORCH!!!!!!!! HA HA HA
