Page 1 of 1
clutch master cyl.
Posted: Wed Mar 05, 2008 4:23 am
by what huh
Will this work for my 5 speed swap.
here is the link
Posted: Wed Mar 05, 2008 9:23 am
by Aerotech
JDM = Right Hand Drive. Probably won't fit US cars the way it's set up.
Posted: Thu Mar 06, 2008 8:19 pm
by Legacy777
What the hell are all the extra lines for...? I don't even see where that last one goes.
You could probably use it if you capped off the one port, and ran a custom flex line. Assuming that everything fits clearance-wise.
Posted: Fri Mar 07, 2008 3:51 am
by Blackbart
That should work for you, cap of the extra lines and rethread the plunger shaft, the JDM's are longer than the USDM's. You need to add another inch or so of thread so that you can screw the U shaped end down further so that is is the same distance from the MC as the USDM.
Posted: Fri Mar 07, 2008 4:29 am
by what huh
well its all good mike270 is hooking me up