legacycentral bbs

I need an engineering technical drawing of a Legacy Turbo rotor.

Has anyone seen one or have one?

Thanks!

I don't think you'll find one. Your best bet would be to contact brembro or another brake rotor manufacturer/vendor.

Are you looking for certain dimensions?

It shouldn't be too hard to create one, particularly for the front rotor.

However, I'm guessing you are talking about the rears since I know you've got your cool side project going on .

Which dimensions are you looking for or would need on a drawing?

I ask because I have access to a couple of modeling programs....

There's a dba drawing of the front rotor in the sticky (just click on the dimensions). I don't have one for the rear but it would be pretty easy to get most of the dimensions from the 290x18 rotor.

Thanks guys,

I got it. I just had to confirm a few issues that we were having. I ended up drawing my own tech. drawing (by hand! OG style). Everything turned out exactly as I expected, so no worries.

Can you guys keep a secret?

only if you PM me.

^^^ Agreed.

Nevermind then. I'll wait until we go to production before posting a teaser of the 316 kit.

Ahhh, how are you going to do that to us. You can atleast post an un-titled picture. I assume it works?

When is production going to start, is it for the 316 and the 290?

Well, you guys said you couldn't be trusted...

Does it work? Still pre-production, can't disclose.

What should you expect?


IF the kit goes to production... Both might go.

Hahaha....

I know you can trust me. And I'm really hoping this goes to production. I'll be upgrading to WRX fronts here in a few weeks and need something to bring the balance back.

If both kits need tested, I already have 290 rotors from an 05 LGT.....

Lol, thanks for the offer Lee. I've got the kits in the back of the Forester. I'll be testing and approving both options.