legacycentral bbs

i suspect i spun a bearing. im in winnipeg canada.

anyone have one?

I'd send these folks email...Barret Dash is the owner. He usually has access to a variety of options. I bought a car from him and trust him...

http://www.allwheelsdriven.net/

Of course Blackbart is a terrific vendor too. Entire engines? Not sure...

I've got a whole one down in CT. A bit far and shipping would suck, but if you need it, let me know.

hoping to find one in canada, not sure what kind of hassles the border will bring. but a few people seem to have them laying around.

If you want just a crank I have one. But I'm rebuilding the engine.

thanks guys, keep the offers coming im weighing my options riight now.

You can replace the crank & rod bearings & have the crank checked out by a local machine shop to see if it's still ok to use or not. Frank (Blackbart) has 22T internals. I already took 2 sets off his hands for builds I am doing for my buddies.

yea i'd give a +1 to a rebuild, just finished mine only took a month and a half, cost was $1300

and if your gunna scrap a ej22t i might be interested in taking it off you hands.

evolutionmovement has one for sale

i cant spend over 1000 on rebuilding.

id like to spend 5-700 for a running motor to swap in. this is my dd beater car, i have a turbo civic which was supposed to get the money, but now i need to fix the subaru.

hey good morning. have a post up about an engine. it came out of a donated car. they go thru the junkyard adn are usually junked.

my guy can get a hold of the parts if he knows someone is looking. thing is I have act fast usually. he will not hold anything for anyone.
to long.

but yea if your interested holla at back asap please.

question is what has to be done to ship it to you? and how much also. would drain oil before shipping. also p/s as well.

let me know cause I am not to good at shipping.

be well, Daniel

juice91si wrote:i cant spend over 1000 on rebuilding.

id like to spend 5-700 for a running motor to swap in. this is my dd beater car, i have a turbo civic which was supposed to get the money, but now i need to fix the subaru.

I'll buy the motor with the spun bearing from you.

pmd

I'd look at the block first - it may be fine and would be cheaper than finding a turbo, shipping it, and still dealing with an unknown quantity. Rebuilding a good block, even buying a used crank, should be under $700. That said, I do have one for sale, but shipping would be a pain.

price?

i found a running ej22t for 1500 for a full swap in canada, but i can get a block from th eus for a third of that, so ill deal with customs.

i dont want to rebuild if i dont have to, i need to dedicate myself to studies,, and my civic. i am not paying someone to build me a motor, id do it myself, but i dont want to because of time and money issues, its just better and easier for me to get a running ej22t and swap it in.