legacycentral bbs

When we did the tranny swap there was a hick-up. the CEL came on and threw code 11 which is a Crank Angle Sensor.

It only comes on when I'm on the freeway cruising at a steady speed.

And the wiring was a f*&^%# up so I re-did all the wiring that was. And I did it damn fine if I do say so myself...

Same problem...

I guess I'll replace the sensor tomorrow and see if that does it. Heres hoping.

Oh and I did pull it out and clean it to try and fix it. But it still didnt do anythin!

Any other thoughts or should I just replace the sensor?

When I was doing my trans swap wiring all of those wires and connectors on the bellhousing were hard as a rock. Just a slight nudge was enough to crack and possibly break them.

I had the whole harness unwrapped, so I replaced them with lower milage examples.

I would check the connectors and wires very closely.

Mine werent too bad... but I basically made my own wiring harness...