Page 1 of 1
HKS JDM Axleback, CES Downpipe
Posted: Fri May 30, 2008 7:26 pm
by Blackbart
Posted: Fri May 30, 2008 10:28 pm
by dropdfocus
That's a damn good deal for the CES pipe guys!!! Frank is setting someone up for a killer purchase. Too bad I already purchased an Invidia DP, otherwise I'd be all over that.
Posted: Sat May 31, 2008 12:18 am
by Legacy777
What's up with that axle back??
Posted: Sat May 31, 2008 12:22 am
by asc_up
Would that be $250 shipped for the DP?
Posted: Sat May 31, 2008 4:06 am
by dropdfocus
Typically that acts as an inline silencer of sorts.
Posted: Sat May 31, 2008 4:34 am
by Arctic Assassian
I think it makes it scream a little more. It definitly traps certain frequencies.
Posted: Sat May 31, 2008 5:13 am
by 93Leg-c
Perhaps I haven't been observant in the past, but it looks like the primary and by-pass pipes have sections welded in the middle. Has it always been that way?
And I wish I had the funds to buy it!
Posted: Sat May 31, 2008 1:28 pm
by Blackbart
The tank is closed at the end, it is some kind of silencer, similar to an anti-hammar device found in some domestic water systems.
Posted: Tue Jun 03, 2008 2:58 pm
by Blackbart
I would like to sell these as a set for $500 shipped.
I will also sell them individually if the axleback goes first.
The DP is a work of art.
Posted: Wed Jun 04, 2008 3:53 pm
by Threshld1
Whats the length from the rear hanger on the axle back to the end of the tip? It looks as if it would hang out a mile past the bumper. Any issues with the sway bar and the resonator on an SS?
Any sound clips by chance?
