Page 1 of 1
want a hood for 1990 legacy ls
Posted: Sun Jun 01, 2008 7:49 pm
by SILINC3R
is there a hood woth a scoop that will fit my car.
Posted: Mon Jun 02, 2008 5:19 pm
by Legacy777
Get a turbo legacy hood for a 1991 legacy turbo. Or cut a hole in your hood.
Posted: Mon Jun 02, 2008 5:44 pm
by SILINC3R
would it fit nicely or would i have to fabricate
Posted: Mon Jun 02, 2008 6:03 pm
by Legacy777
The 91 hood, or cutting a hole in your 90 hood?
The 91 hood will fit fine, bolt on.
Cutting...obviously you'll need to do some custom work.
Posted: Mon Jun 02, 2008 6:04 pm
by Dynamic Entry
any hood from any 90 or 91 Legacy will bolt on directly
Posted: Mon Jun 02, 2008 6:04 pm
by Legacy777
Any 90-91 MY Legacy hood is interchangable.
Posted: Mon Jun 02, 2008 7:53 pm
by SILINC3R
yea i meant the turbo hood. was that interchangeable. how much and where could i get one
Posted: Tue Jul 01, 2008 7:24 pm
by jp233
Hey since i see you're in Georgia, there are a few good 90-94 Subies at Pull-A-Part (Atlanta North). Well, the ones I haven't raided yet.
I know the Atlanta South location has a few cars too, but I haven't been there.
There are two good '91 hoods there at the ATL North spot, albeit they aren't turbo cars. But, since they are only $28.71 at the pullapart... you could buy one and then hack it up without worry if it gets screwed up.
Yes, all 90-91 hoods (turbo or N/A) are interchangeable.
I am assuming a 91 hood won't fit right on a 92-94, due to the headlight change?
Posted: Tue Jul 01, 2008 10:45 pm
by SILINC3R
hey could you get me directions
Posted: Wed Jul 02, 2008 12:41 am
by jp233
www.pullapart.com
they are also supposedly opening another yard in Lithonia GA
Posted: Wed Jul 02, 2008 2:37 am
by SILINC3R
i think iwent to this one and they had a wagon. i will nee to check it out again